Why is My Dishwasher Leaking?

Coming downstairs only to step in an ominous puddle on the floor is never the best to start the day.

Fortunately, most common sources of dishwasher leaks are comparably straightforward to determine and mend on your own. This means you might not have to hand wash the dishes for too long, wait for the repair man or need to pay a high call-out charge.

So, grab the operating manual if you have it, clean up the mess and so get something soak up any further leaks and so find out whether you can’t find a DIY solution. If you cannot call us for local dishwasher repair.

Common Causes of Dishwasher Leaks as well as How to Fix Them

A lot of the most commonplace causes of dishwasher leaks are not actually because of a broken dishwasher at all. Before you start getting the tools out and also looking at numerous youtube tutorials there are a few problems you should troubleshoot first.

  1. Check to see whether your dishwasher is level. If the dishwasher is not level water can quickly puddle and so leak regardless of whether or not the dishwasher has a fault.
  2. Investigate you are using the right soap. You might have seen this with your washer. Too much detergent or using the wrong variety could result in an excess of soap suds, the suds overflow and you get a leak.
  3. Investigate your dishwasher door fully closes. If it doesn’t there may be an obstruction, or you could need to replace the hinge or the locking mechanism.
  4. Check the filter located in the base of the machine for any obvious obstructions because if your dishwasher isn’t draining effectively this is likely to result in overfill and so leak.

If none of the above issues apply it’s time to get ready and really start a thorough check.

The easiest place to start is the door as well as check for any obvious problems inside of the machine before you move on to the underside. If you can identify and so resolve the problem without pulling out the dishwasher you’ll save yourself a lot of hassle.

Also make sure you disconnect the appliance first by either unplugging it or turning off the circuit breaker for the dishwasher.

Door Seal

The door is probably the most commonplace area for leakage as well as one of the simplest problems to fix.

If the leakage is intermittent the fault might be as straightforward as an oversized dish or another object pushing against the door thus stopping it from sealing properly.

Else-ways the door seal might have been dislodged or been split.

Inspect the door gasket and also check for any cracks, mineral deposits or other gunk, or any areas in which the seal has come away from the door.

Removing the gasket and giving it a good scrub could help in some cases or you may be required to acquire a new seal and replace it.

Water Inlet Valve (Solenoid Fill Valve)

The inlet valve can also be a everyday fault. It is in most cases situated underneath the machine therefore you will most likely need to take off the kick plate and may have to unscrew the door cover.

The fill valve opens and closes to let water into the dishwasher at various parts of the programme. The water inlet valve might be damaged, demonstrated with a slight drip, or it might be damaged and so not opening or closing correctly throughout the programme.

If the inlet valve fails to close correctly this can mean that the dishwasher overfills, causing a leak.

Often these valves can’t be fixed, thus the entire component would have to be replaced.

Leaking Hoses

Hoses are needed to supply, empty and also redistribute water during the programme.

Two issues can arise where hoses are concerned.

  1. The gaskets could go or the contact points can come loose meaning it’s a good idea to have a look at all the connections .
  2. The alternative problem than might easily happen as you use the machine is that hoses could be degraded or cracked.

Luckily damaged hoses are relatively simple to procure as well as replace.

Pumps and Seals

You can visually check the rubber seals around the pumps or motor to determine whether there is a leak and change them if there is.

The Float Switch

The float itself or the float switch could be damaged resulting in the dishwasher overfilling.

A working float will rise with the water level until it reaches the desired fill level. The tag of the float would then turn on the switch. If something is blocking this or the float is broken this could be causing your problem.

Testing the switch would need a multi-meter although it might be noticeably broken in which case replacing it should resolve the problem.

Alternative Components that Might Lead to a Leak

A damaged wash arm or support may force water under the door resulting in a leak. This can likewise often affect how well your dishes are being cleaned.

Broken or cracked lines could also cause this issue as might a loose pump cap.

The motor shaft seal might have cracked causing leakage. This will generally show as leakage coming from the underside of the dishwasher.

Top Tips to Sort Out Your Dishwasher

  1. Spend less by checking the gasket rather than the whole part. In most situations, you are able to acquire the seal without the rest of the part which saves time as well as money.
  2. Investigate the simple fixes first. There’s no point pulling the entire machine out if the problem is the soap.
  3. Take photos at each step. This can help you put the machine back together, show the part you need to a sales person, and also explain the issue to an engineer if needed.
  4. Stay safe. Water and electricity do not mix so turn off the power first.
  5. If you’re not sure get in the professionals.

What To Do Next If Your Initial Investigation Fails to Disclose or Fix the Leak

If the root of the issue is still a mystery the thing you could do is to pull the dishwasher away from the wall to get a better look beneath it and fill it with water to see whether the leakage can be seen that way.

If you don’t uncover any leaks with this method your machine could only leak if during a cycle. In this instance, you should employ a qualified technician to pinpoint and resolve the problem as there are safety risks of checking for faults with electrical components uncovered.

More Dishwasher Problems:

  • Dishwasher Being Loud
  • Dishwasher Not Turning On
  • Dishwasher Not Draining
  • Dishwasher Not Drying
CLICK-TO-CALL